Discharge Housing Assembly

Jason for Model Number Maytag MDB6650AWB

Answer Hello Jason, Make sure that you double check to make sure that there is nothing stuck in the pump assembly. If not then you would have to replaced your motor assembly 6-917112. 

Craig for Model Number mdb7100 or mdb7160

Answer Hello Craig, The entire problem is with the discharge housing assembly 6-917075. If that part that comes off can come off, it has to be replaced. When the pump spins, this part is causing the roar and since the water has to be forced through this parts fins, it cannot discharge correctly. Replace this part and the issue will be gone. The "o" 99001326 ring should be replaced also. The overuse of soap and rinsing all of the dishes has caused the chemical reaction to attack the rubber and the "o" ring will never be right unless it is replaced. 

J.d.g. for Model Number MDB4100AWB

Answer Hi Jd. Check the drain hose at the end where it hooks on the end of the sink. Put it in a bucket and press cancel or drain. Is it working? Clean all internal filters [part # is AP4112901] and wash arms. Check the sink drain to see if anything is clogging there also. Do you hear the pump? The pump/ motor is part # 6-915415. Thank you. 

Gardner

Answer Gardner, The discharge housing is not the issue. It produces pressure to the wash arms in the wash cycle. Apparently this is a Mayatg dishwasher and it probaly has a two direction motor, so do you hear the motor reverse and the pump attempt to drain ? Try disconnecting the drain hose from the displosal or air gap and see if it will drain, you may have an obstruction in the line. Thanks and Good Luck 

Mark for Model Number Jenn-air JDB3610AWX

Answer Hello Mark! Remove the screws and wiggle the part out. It might be a tight fit. Thanks.