Dispenser Assembly

William L for Model Number ghw9150pwo

Answer William, The control lock can be disabled by pushing the end of cycle signal for 3 seconds until the control locked status light turns off. 

Brad B for Model Number ghw9150pw0

Answer Hello Brad, It sounds like you may not have gotten your hoses to the dispenser reconnected tightly or the tube that comes to the bellow is kinke and forcing water back up over the dispenser. Double check all hoses and connections. 

Quant for Model Number GHW9200

Answer Hello Quant, You may want to pull the dispenser assembly and try to clean assembly. It sounds like the water distribution lever is not working properly. It may be gummed up causing the issue. If this does not work then you would want to replace the Actuator motor 8181723. 

Newnanny for Model Number GHW9200LQ

Answer Hi Newnanny. Look at the detergent container part # 8181722, and the siphon cap part # 8182665 to see if they are clogged. Use the sink to clean and flush out both parts for proper flow. If all of these parts and the detergent separator part # 8181730 need periodical cleaning to insure the proper flow. The dispenser assy. part # 8182704 does not include these parts. Thank You. 

Newnanny for Model Number GHW9200LQ

Answer Hi Newnanny. Look at the detergent container part # 8181722, and the siphon cap part # 8182665 to see if they are clogged. Use the sink to clean and flush out both parts for proper flow. If all of these parts and the detergent separator part # 8181730 need periodical cleaning to insure the proper flow. The dispenser assy. part # 8182704 does not include these parts. Thank You. 

Mark

Answer Mark, no the dispenser assembly 8182704 does not include the spring loaded actuator. To make sure we provide the correct parts for your unit we will need your appliance model number. Thanks.