How to replace dispenser.
Rich K. for Model Number MVWB300WQ1
Answer Rich, First Unplug washer or disconnect power. Turn off the water supply to the washer. Tape the lid down. To raise the top. Remove top screw from each hinge on back panel. Remove wire harness cover. Slide the top forward about 1/2". Raise the top about ¼ ". While still keeping it lifted, push the top back about ¼ ",Tilt the top up on the rear hinges. To remove a dispenser: a) Use a small screwdriver and pry out on the three dispenser cover tabs while you lift the cover off the dispenser. Squeeze the bottom of the dispenser, and release the hooked segments at the top of the dispenser from the cabinet, then push the dispenser out of its cutout. Raise the cabinet top. Loosen the clamp and disconnect the end of the dispenser hose from its water inlet/dispenser valve connector. Reverse the procedure and test the washer for operation.