When the dishwasher starts its cycle, it leaks very bad in the middle on bottom of door. What part do I need and is it hard to change out?
Mark for Model Number GU980SCGB2
Answer Mark, There are several checks to make, check the inner door panel 8193770 with a straight edge, it could be warped. Check the lower spray arm 8268874 for a split seam or debris in the spray openings and the bearings for excess wear or damage. You could also verify the spray arm by blocking it in palce through the lower rack in a side to side direction and see if the water leaks when it washes. Check and make sure the dishwasher is level and the water level in the bottom of the tub is not above the top of the heater element. Thanks and Good Luck
DISHWASHER STOPS WORKING AND THE RINSING ,WASH,AND CANCEL LED LIGHTS BLINK ON AND OFF
Joe for Model Number GU980SCGQ2
Answer Joe, You want to start by checking or replacing the control panel/keypad assembly 8051710 " ERROR MESSAGES STUCK KEY:
If the control detects that a key is stuck in the depressed position, dishwasher operation will be suspended and the control will flash
the light for that key until the condition is corrected. If a key without a light is stuck or multiple keys are stuck, the control will flash the
Lock-Out light." Thanks and Good Luck
Blue light blinking on door. Will not run ?
C.f. for Model Number Gu2475xtvyo
Answer Hi C.F. We will need more info. Specifically what blue light and what indicator is it flashing by ? Is it the start/ resume key ? If so then replace the door latch assy. part # W10142939. It may also mean the keypad is shorted part # W10175239 Blk. White is part # W10175240. Silver is part # W10175241. Use the supplied tech. sheet in behind the toe kick will allow you to use the field service mode to decipher which circuit , wires or device is the issue. Thank You.