Door Boot Seal

Guest

Answer Hello. You will need to remove the top panel, then remove the control panel. Open the door and remove the boot spring and boot from the front panel, and remove the front panel. Once the front panel is removed, you will see a band around the back of the bellow. Remove this band, and reinstall in reverse order. Hope this helps. 

1 person found this answer helpful.

Adam for Model Number MHW6000XW0

Answer Hello Adam. Here is a video to help. The model is different, but installs the same. http://www.youtube.com/watch?v=uv-3MSL06oA&list=UUnMCOX6qSbTUQPyJJzRwPcg&index=8 

Albert for Model Number MHWZ400TQ00

Answer Hello Albert. Remove all the screws securing the panel. Then you unsnap the panel from the cabinet on the unit. Make sure you have removed the dispenser and the screws behind it. 

Joe for Model Number WFW8400TW03 Whirlpool duet

Answer Joe, the door boot seal W10111435 does not include the clamps part numbers 8540108 and W10217563. Thanks! 

Lisa for Model Number MHWZ600TB00

Answer Hello Lisa, To remove the door boot you would unplug unit. Turn off water supply, and remove top cover and console. Remove the lower front access panel. Open the washer door and using a small screwdriver or needle nose pliers, pull the tension spring on the retaining wire out from the front of bellow and remove wire. Remove the front panel from unit and take off the bellow retaining clamp. Remove bellow and install new. Reassemble in reverse. 

Susie for Model Number WFW8300SW04

Answer Hi Susie, depending on which clamp you need, use W10217563 for boot seal to front panel or [AP38662870] for boot seal to tub. Hope this helps!