Same problem on how to take handle off for freezer what size of set screws are they, all most ready to come off. Can you send me a diag. Thank You.
Answer Hello Dave,
You would need to use an allen wrench size 3/32". If you have your installation this will be on page 8 under metal handle installation.
how do i tighten the handles?
Answer Phillip, First you will need to remove the handles(one at a time) tighten the door handle stud screws on the door panel, then reinstall the handle. We'll send you some information that should be helpful. Thanks
How do I remove the old drawer freezer handle. One side is still attached.
Answer Julie, Here's the inoformation you requested "Remove and Replace Drawer Handle: Metal Handles ¦ Using a ³/32" Allen wrench, loosen the two set screws located on the side of each handle. Pull the handle straight out from the drawer. Make sure you keep the screws for reattaching the handles. ¦ To replace the handle, reverse the directions. Plastic Handles ¦ To remove the handle, grasp the handle firmly, slide the handle to the left and pull the handle straight out from the drawer. ¦ To replace the handle, position the handle so that the large holes in the mounting clips are to the right and align the holes with the door studs. Rotate the handle so that the mounting clips are flat against the drawer and slide the handle to the right to engage." Good Luck and Thanks