The fill valve only receives 40 volts. The. Unit received 120 volts, with continuity in both fill valve + over fill switch. The control looks to be in good shape, but I cannot access door panel. Any suggestions as to where the resistance is + how to access wires within it. Thanks. RC
Rc for Model Number KUDS01DLSS1
Answer RC,
The fill valve should have a resistance value of between 890 and 1090. You will want to check this from the control board from connector P2 pin 3 to Connector P10. This will also trace the circuit to make sure that there are no broke wires. To access the control board you will remove the screws around the perimeter of the inner door. Also check to make sure that the board is sending power through the same pins to the water valve. If not then the control is bad and if so then there is a wiring issue.
My maytag dishwasher works fine except that iof I open the door during a wash cycle it still keeps running! Does part AP4113223 fix this and is it hard to replace?
Sal B. for Model Number DWU8860AAX
Answer Hello Sal. Yes, based on the information you provided, the latch assembly 99002254 is bad and will need to be replaced. These are not hard to replace, just remove the inner door liner to access and replace the part. Make sure the power is disconnected in the unit before doing the repair.