Door Switch Assembly

Doug J. for Model Number 110.45091401 Kenmore HE Washer

Answer Hello Doug. You will need to check and see if the shocks 8182703 are wore or broke on the unit. If so, they will need to be replaced. You can remove the front toe panel and the rear access panel to check them. Hope this helps. 

1 person found this answer helpful.

Sherwin C

Answer Hello Sherwin. The latch is what goes inside the lock switch. The correct latch will be determined based on your model number. Hope this helps. 

1 person found this answer helpful.

Dixie for Model Number whirlpool duet washer

Answer Hello Dixie. Unplug the unit. Remove the pressure switch hose and blow through the hose. Once the chamber is clear, if the code continues, replace the pressure switch. If it is still there, then the board will have to be replaced. 

Kenmore Elite HE31 2004 for Model Number 110.4596 4597

Answer Hello Maria. First thing to check is the wiring harness. Last thing to replace is the board. Most likely bad connection on the wiring of the unit or a bad wire. 

Cw for Model Number samsung front load washer WF410ANR/XXA

Answer CW, The "LE" code in the display would indicate and issue in the water level, you'd want to check the water level sensor switch DC97-03716C, Remove and blow into the tube to make sure it's not clogged with sediment or debris and has an air tight fit at the switch and tub connection. Then consider the control board if all else checks OK. 

John for Model Number GHW9100LW1

Answer Hello John. If the door switch is bad, it will prevent the unit from working, but you should get an error code. Check the water valves and make sure they are good and if so, you may need to replace the user interface on the unit.