Dryer Drum Felt Seal

Bob for Model Number LDE8426ACE

Answer Hello Bob, The 2 ounce tube Y055980 should be sufficient. It doesn't take much because if you use too much, the excess squeezes out anyway. Most people use too much while a small amount is all that is needed. 

Husson A for Model Number LDG4000

Answer Husson, The dryer is equipped with a 22,000 BTU per hour burner. Depending on how many loads are dried and how long it takes to dry a load, it wont take long to consume 30 lbs (15Kg) of LP or Butane gas. It actually sounds within expectations. 

Artie for Model Number DG412

Answer Artie, you most likely have a "beige" colored drum. The manufacturer eliminated the high temp adhesive and glue doen seals, when they started using the beige tumbler and bulkheads. You should be fine with the part you have. Just remember , do not cut the seal, it is designed to overlap and fit inside the other end. make sure you install the end of the seal in the tumble direction, if incorrect, it will have a tendency to pull out and get caught in the clothes. Good Luck and Thanks 

Mary L for Model Number maytag dryer DE882

Answer Mary, Yes you could install the felt drum seals yourself 314820 and you'd need to order some High temperature adhesive Y055980 to secure the seals to the bulkhead. It will require a bit more work, to replace the rear seal (almost a complete teardown), but It's pretty easy and do able. Good Luck. 

Richard M. for Model Number 2108233148

Answer Hello Richard. This is one felt seal 314820. Hope this helps.