I got this clock control with no instructions on how to connect the plugin wires onto the new one which is different than the old one which I have already return for the core charge. The stove is RF361BXDw 0 Thanks
Stone Rose for Model Number part # 8190664
Answer StoneRose, Did you not recieve the instruction sheet with the new control you orddered (instruction sheet 8190665) ? We'll be sending you the instruction sheet and the wiring diagram to assist you in wiring the new control. Thanks
Follow up to above question. I notice that the new part installed is quite different looking from the original part. Is that a red flag??
Jerry for Model Number RF363PXDNO
Answer Jerry, the electronic control 8190664 has been redesigned from the manufacturer and may look different than the original however, it will work on your unit. Thanks!
We purchased the electronic control about a year ago from you. I installed it and the stove worked fine. We do not cook very much and seldom self clean the oven. Several weeks ago my wife decided to use the self clean cycle and we got a message FSEO after the clean light and time expireed. Please advise. JM
Jerry M. for Model Number RF363PXDNO
Answer Hello Jerry,
Here's what the tech. sheet says:
F5 E0
Door and latch switches do not agree 1. If door is latched:
A) Disconnect power from unit.
B) Check wires and connectors from control to door switch, then from door switch to control. If no damage found, proceed to step C.
C) Replace door switch.
D) Reapply power to unit for more than 1 minute and verify operation.
2. If door is not latched:
A) Disconnect power from unit.
B) Check wires and connectors from control to latch switch, then from latch switch to control. If no damage found, proceed to step C.
C) Repeat steps A) and B) for door switch.
3. Measure door switch (door open = switch open small low voltage terminals).
4. Measure latch switch (unlatch = switch open, CAUTION - oven light contacts are closed).
5. If corrections are made in any step, reconnect power and verify correction.
6. Check door alignment.
7. If failure remains, disconnect power, replace control.
Door Latch Assenbly 3148668
Electronic Control 8190664