Can I install this part myself?
Vinnie for Model Number kebc208kss03
Answer Hello Vinnie. You can install this part yourself. You will need to disconnect the power going to the unit, and remove the screws holding the element in place. Once the screws are removed, you will pull out the element and disconnect the wires. Reinstall in reverse order. Hope this helps.
1 person found this answer helpful.
I think my heating element is bad on the top oven. Only the outside loop on the coil makes heat. The inside stays cool and the oven take a long time to heat up - twice as long as the bottom oven. Is this a bad heating element?
Bill for Model Number kebs277dbl9
Answer Bill, You'll need to remove the broil element and check the resistance of the inner element (45 to 55 ohms resistance) with a multi meter. If the element checks proper W10207400, the issue would be in the wiring or the control board relay 4453661 not supplying power to the inner element. We're sending you some additional information with the relay cycle charts so you can check and verify the issue. Thanks