My issue is that somone else took the erc out and I'm not sure of where the single wires go on the new erc. Thanks John
Answer John, We're sending the "tech Data / Wiring Diagram" to you via your other email address. You should be able to wire the ERC and Be up and running in no time. Good Luck and Thanks
Regarding the F1 symbol that keeps popping up, how do I determine whether I need Part # AP4041348, the ERC control module, or Part # AP4041648?
Answer Hello Chris! Here is a test you can do to help verify which part you need to correct your F1 failure code. Hope it helps!
This simple test will help determine whether the ERC (Electronic Range Control or Clock) or the touch pad is defective when F1 error code is present.
Note: Some models incorporate the touch pad in to the ERC as a single assembly, in which case this test is not necessary. Simply replace the ERC (Clock).
Warning: If you feel in any way uncomfortable performing this test or making this repair, please contact a qualified appliance repair technician.
1. Disconnect power to the range (unplug the range power cord or turn the power off to the range at the circuit breaker). It is very important that the power to the range has been disconnected, so please double check before continuing.
2. Gain access inside the control panel.
3. Disconnect the touch pad (also called keypad or membrane switch) ribbon from the ERC.
4. Make sure there are no lose wires, or anything else that may cause a short when power is turned back on. Assemble the control panel back the way it was.
5. Turn the power back on.
6. Wait for at least one hour to see if the F1 code comes back (usually accompanied by a beeping sound).
7. If F1 comes back, replace the ERC. If it does not, replace the touch pad.