The buttons for the ice and water have worn out and don't work anymore. The facade has been cracked for a while now but the buttons still worked. Now they don't! Do I need to replace the entire unit, Part # AP4080127 , or will the facade, Part # ap4080089 do the trick?
Answer Dave, Based on your post, the best bet would be to replace the facade 67004284 and the control board 67003817 (or at least have it handy, it sounds like you may need it as well). It's not that hard a repair to make, " Dispenser Facade (some models) 1. Remove drip tray by pulling it straight out from door. 2. Remove two hex screws at the bottom of facade that were hidden by drip tray. 3. Push down on facade to release retainer clips. 4. Remove facade and disconnect ten pin connector from control board. 5. Reverse procedure to reassemble." I think you'll be a lot happier in the end.
My facade has 3 soft touch buttons, cube crushed and water. Do you have that part?
Answer Hello Joe. Based on the information you provided, 67005756 is the correct part you will need to order.