How difficult to install?
Answer David, Heres some basic information, so you'll have an idea. Unplug air conditioner or disconnect power. Remove the air conditioner from the window. Remove the side curtains and the front grille. Unclip the temperature sensor tube from the sensor holder. Remove the lower screw from the two green ground wires that are mounted to the evaporator.Remove the four screws from the control mounting plate and allow the assembly to hang off to the side. Remove the four screws from the brace and remove the brace. Remove the eight screws from the top air guide. Lift the top air guide off the upper styrofoam air shields and rotate the guide to the left, (facing front). Lay the guide on the work surface out of the way.10. Loosen the clamp screw on the condenser fan blade and slide the clamp off the fan. 11. Remove the two screws from the condenser fan shroud.Remove the two fan motor clamp screws and remove the clamp. Carefully lift the fan motor assembly, the condenser fan shroud, and the lower styrofoam air shield, and remove them from the unit.Pull the condenser fan blade and fan shroud off the fan motor. Loosen the evaporator fan screw. NOTE:Use the slot in the fan blade to access the screw.
Pull the evaporator fan off the motor shaft. Good Luck and Thanks