Fastener, Spring

Bob Pij for Model Number maytag lat3600aae

Answer Hello Bob, To remove front panel you will push in on the spring clip on either side between front panel and main top. Lift top and remove 2 screws holding front panel in place. Once you do this the front panel can be removed. 

Bob for Model Number LAT8650AAW Maytag

Answer Hello Bob, There are no instructions or videos for installing the spring clip. The clip attaches to the retangular opening on the top of the front panel of the unit. There is one on either side and the curved part faces forward. 

Wooty for Model Number lat9635aae

Answer Wooty, Did you check the inline fuse obn the lid switch for a "closed" circuit or 120 VAC on each side of the fuse? You also want to check for a closed "circuit" on the check switch (red wire to double yellow wires) with the lid down. If the switch is not closed, there won't be power to the motor and it won't run. and the other switch has to have a "closed" circuit from blck to the double red wires, or there won't be power to the check switch. Good Luck and Thanks 

Frustrated for Model Number A883 Maytag Top Loading Washer

Answer Hi Frustrated. I can help. I know that the wider - lip of the flat spring clips position into the front side of the front panel. Insert the wider lip of the clips in first and then pry the other side of the clip into the cut out facing the inside of the front panel. Then you want to align the front panel assembly and from the bottom up you will align up the clips from the panel to the underside of the lid. Then put the bottom of the front panel onto the frame and align the lower screws to install. I hope this helps. Thank you. 

Roger & Carolyn for Model Number NAV5800AWW

Answer Roger, can you isolate the noise to a specific area, bottom of the washer, bottom of the tub, top of the tub etc. At this point it sounds like you have a worn out spin bearing/milk stool and or tub bearing assembly,W10116790 , 40004001, it's a pretty involved repair, but it's do able. Thanks. 

Greg for Model Number LDE8904ACE

Answer Hello Greg! Here is the information supplied from the manufacture on how to remove the top and covers: Console: Disconnect power supply. Remove control panel assembly. Remove eight screws, two on each side and four across the front, holding console to top cover. Top Cover: Disconnect power supply. Remove fron panel. Remove two screws (one in each front corner) which hold top cover to cabinet. Remove main wire harness from components on control panel. Remove control panel assembly. Pull main wire harness through opening in top cover. Remove console. Push top cover back to disengage from cabinet and remove top cover. Cabinet Removal: Disconnect power supply. Remove front panel. Remove top cover assembly. Remove tumbler. Remove tumbler rear. Remove six screws (three on each side) holding cabinet to base frame. Hope this information helps!