Filter-Se

Gino for Model Number LAT8614AAE

Answer Gino, You will want to make sure that your drain is not clogged causing unit to not drain completely. Also check to make sure that the unit is going through the drain cycle. If not then the unit will keep hair and soap in it. This would be between the wash and rinse cycle. Check the belt on the drain pump to make sure that it is not worn. 

Kelvin for Model Number LAT8714AAE

Answer Hello Kelvin, The unit has 1 filter for the tub. 

Larry for Model Number LAT8804

Answer Hello Larry, Check your exhaust duct. You see, the dryer drum rides on felt seals. If you get too much back pressure, the excess pressure will blow past the dryer drum seals and the lint, heat, and moisture will all be reintroduced to the area where inlet air is brought into the unit. This air, lint, heat, and moisture will be recirculated across the clothes and cause excessive dry time and lint complaints, not to mention the premature failure of parts sensitive to heat and moisture. 

Linda

Answer Hello Linda. The filter goes under the agitator. You will need to remove the bolt and lift out the agitator to replace the filter 207219. 

Jack for Model Number LAT8234AAE.

Answer Hello Jack. You will need to remove the bolt and lift out the agitator to replace the filter 207219. Hope this helps. 

Manny for Model Number LAT8714AAE

Answer Hello Manny. Yes, you will need to remove the agitator to replace the filter 207219. Hope this helps.