Fitting

Nadine for Model Number Whirlpool ED5LVAXVB00

Answer Hello Nadine. The only way to replace the water line in the door is a new door assembly L2263883B. 

James for Model Number Whirlpool Refrigerator Model GD22DFXFW02

Answer James, sounds like you will need to replace the fitting. The part number is 8201537. Thanks! 

Bobbie for Model Number ED5FHGXKQ00

Answer Hello Bobbie, We do not have a video to help install part. The way that you install the part you will have to remove front cover from the dispenser. You do this by using flat blade screwdriver under at the bottom of panel and pry out. This will pop the dispenser assembly out. You would then remove the dispenser bracket and remove the screw that holds the water line in place. Remove the lower kickplate of unit and disconnect hose that is at the bottom of door. Once disconnected you can do one of 2 ways to get the new water line in. You could pull the old out and just push the new one thru, you may have to lift door off hinge to get the line out of the door and through hinge. You could also tape the 2 ends of the old and new hose together and try to pull through from the bottom of the hinge. Once through reinstall. There should be instructions with he part that tells how the bracket goes on. 

Jimbo for Model Number 106.55649500

Answer the water tube you are needing is the water tube fitting part number 8201537. Here is the link to our free repair forum for installation assistance. Thanks! http://forum.appliancepartspros.com/ 

Ejraleman for Model Number Kitchen Aid

Answer Hello. If all the air is out of the lines, you will need to replace the water valve if the water is leaking in the unit. 

Priscilla B. for Model Number KSRB25FHss01

Answer Hi Priscilla. The fitting part # is 8201537.Here are the instructions from the manufacture. Hope this helps. Installation Procedure 1. Unplug refrigerator or disconnect power. 2. Remove existing water tube and/or bracket. 3. Install the bracket using the screw. 4. Slide tubing of the valve assembly into the water tube conduit. 5. Place heat staked joint portion of the valve assembly into the notch of the bracket. 6. Press the tip of the valve assembly into the bracket such that the bracket tab locks into the hole. 7. Remove slack in tubing by pulling from bottom of door. Verify that the valve assembly is vertical and seated properly in the bracket. 8. Cut tubing to appropriate length and connect to reservoir union. 9. Run several glasses of water through device until drum section is full. Drum fills only by cyclic dispensing not continuous dispensing. 10. Verify that there are no leaks at union or valve assembly. Thank You.