Whirlpool 98007411 Gas Pressure Regulator

Total
$0.00

Part Number:	AP3596575
MFG Part Number:	98007411
Made by:	Whirlpool

Our Price
$89.65
Regularly	You Save
~~$106.68~~	$17.03

Most Interesting

Oven does not get hot. The ignitor glows but it seems like no gas is coming thru.

Noni for Model Number sf3020ekq3

Answer Hello Noni. Test for 3.2-3.6 volts AC at the gas safety valve with the igniter turned on. If the voltage is there, you have a bad safety valve. If the voltage is low, you have a weak igniter and the igniter will need to be replaced. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Was this helpful?

When we turn on oven it lights ok, but flame keeps low even if you turn knob fully on flame will stop on.

Mr M Bott for Model Number rangemaster 110 gas cooker

Answer MR M Bott, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Was this helpful?

When I turn the gas on to my oven it smells like gas from the pressure regulator. How do I fix the problem?

Richard for Model Number tgf317esd

Answer Hello Richard. Check and make sure none of the lines on the regulator are leaking. If they are good, and the regulator is leaking, you will need to replace the pressure regulator 98007411. Hope this helps.

Was this helpful?

Latest Questions

Is it easy to put the oven igniter on?

Ms Paula for Model Number SF303PEPQ1

Answer Hello Ms. Paula. The igniter is not hard to replace. Just disconnect the power and remove the bottom of the oven to access the burner cover. Remove the cover and remove the screws securing the igniter. Pull out the old igniter and install the new igniter 98005652 in reverse order. Hope this helps.

Was this helpful?

When I cut on my oven I have to wait at least an hour before it comes on. What could that be? Please help Thanksgiving is coming up.

Ms Paula for Model Number SF303pepq1

Answer Hello Ms. Paula. Based on the information you provided, it sounds like the igniter 98005652 is weak and will need to be replaced. If it takes a long time to heat up, usually the igniter is bad in the unit. Hope this helps.

Was this helpful?

When we set the oven to say, 350 degrees, it will preheat; but during the baking process the oven often shuts off. If we reset the temperature, say to 375 degrees, and try again, it may work. Very sporadic. Very undependable. I'm tired of baking my brownies in my husband's Traeger Smoker.

Droped Loan for Model Number SF315PEPW3

Answer Hello Droped Loan. It sounds like the oven sensor W10181986 may be bad in the unit. Test and see if it reads 1100 ohms at room temperature and 1650 ohms at 350°. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Was this helpful?

Gas Pressure Regulator

Questions & Answers

Appliance Compatibility Tool

Repair Help

Repair Video

How to Replace Gas Pressure Regulator #98007411

Comment on this video

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information