I bought a hub and seal kit from you but i have not been able to get the plastic agitator off the the washer to be able to start the repair? can you please help?
Answer Timm, It's going to be difficult, it's an older unit, but here's the information: " Agitator 1. Open loading door. 2. Remove fabric softener dispenser by unsnapping from agitator. Remove agitator by one of two ways. a. (Auger style agitators) Loosen bolt in agitator and remove by sliding straight up output shaft of transmission. b. (Flex vane agitators) Remove flex Remove flex vane agitator by placing hands under agitator lip and pull upward. If agitator is difficult to remove, use two agitator removal hooks, No. 254PRP under bottom edge of agitator. Remove drive bell by pulling upward, after the drive bell bolt and washer are removed. If drive bell is difficult to remove, use agitator hooks.
NOTE: Hooks must be positioned 180° from each other, and must be placed under base of agitator near agitator vane for greater stability. If hooks are placed between the vane area, agitator damage may occur.3. Using a rocking motion (side-to-side) carefully lift agitator up off drive bell. 4. To reassemble place agitator on top of drive bell. Slowly rotate agitator until fingers on underside of agitator line up with large slots on drive bell. 5. A sharp blow on top of agitator, with the palm of your hand, will force agitator down onto drive bell, allowing
fingers on underside of agitator to lock under bottom edge of drive bell." Good Luck and Thanks
My washer is leaking at the underneath side of the drum. Is it possible that it is the O-ring that I can get to by removing the agitator?
Answer Hi Timm. You will need the hub and seal kit part # R9900552. It comes with the hardware and instruction to assist you in repair step -by - step.You will need to use a spanner wrench TJ90TB123A to remove the hub assembly. Thank You.