I ordered a new refrigerator door gasket part #2188320A. It looks properly installed but when I close the door it springs open about
1/4 inch. Almost like the magnets don't work. Any ideas?
It sounds like the gasket is not formed properly to close. When the door closes you will want to check on the right side of the door and make sure that the seal is not binding against the cabinet on the hinge side. If it is you will have to get it straight and get the door to close. With the door closed you will want to use a hair dryer on low heat and keep it moving up and down. If you leave it in one spot too long it can damage the seal. This will help the door to get a good seal. You will then want to try not to go in the refrigerator for a little bit as to allow the seal to harden back up.