how to install freezer gasket?
Answer MG, You will need to "roll" the door gasket up and over until to can reach the screws holding the retainer strips to the door liner, and loosen the screws(you can remove them if you prefer), there are four(4) retainers, then remove the seal from the retainers. Before you start, you want to take the new door seal and place it in the tub with hot water, so it will be flexible, and easier to work with, when you start to install it on the door. Thanks and good luck
How to install it?
Answer Hello! Pull the old gasket off. It may be best to soak the new gasket in warm water to help take its shape/form. The new gasket will press into the door liner. You may need to use a hair dryer to form the seal, be careful not to melt it. Hope this helps! Thanks.