Gearcase

Ricky for Model Number lcr5232hq2

Answer Ricky, This unit only has one spring for the balancing which would be located at the back of the tub. You will want to check to make sure that the inner tub is in properly and if the unit is leaking from above the transmission case then you will need the tub seal. 

Al S for Model Number Lcr5232hqo

Answer Al, There are several other things you need to check, before you replace a transmission or hub, unless there are obvious noises etc. You want to check for a slipping drive belt, a brake actuator, or worn "splutch". We'll send you some information that should help you diagnose and repair the issue. 

Jacob for Model Number LCR7244HQ0

Answer Jacob, It's a bit more involved than that. "1. Unplug washer or disconnect power. 2. Turn off the water supply to the washer. 3. Remove the top cover from the washer and lean it back against a wall .4. Remove the 5/16? hex-head screw from the side of the agitator.5. Pull up on the agitator and remove it from the drive shaft. NOTE: It may take some force to remove the agitator from the shaft.6. Unsnap the tub ring at the four locations and remove the ring.7. Loosen (do not remove) the wedge screw at the bottom of the basket.8. Pull the basket off the drive shaft and remove it from the tub9. To remove the balance ring from the basket, remove the four screws, and lift the ring off the basket. REASSEMBLY NOTE: When you reinstall the basket, be sure to align the tabs in the shaft with the slots in the basket, and press down firmly so that they are fully mated before tightening the wedge screw." You didn't mention your issue, but this should get you where you want to be. Good Luck and Thanks 

Jacob for Model Number LCR7244HQ0

Answer Jacob, If you're sure the issue is not a loose bolt in the tub or damaged drive hub 285709 Then the issue would be in the gearcase 3966743 it is a "sealed" unit, and will require the complete assembly. here's the how to info " 1. Unplug washer or disconnect power. 2. Turn off the water supply to the washer.3. Remove the agitator and basket.4. Tape the lid closed and lay the washer on its rear panel so that you can access the bottom of the unit. 5. Remove the brake actuator and disconnect it from the brake arm . 6. Remove the two carriage bolts and nuts from the drive motor and remove the motor and the belt. 7. Press the locking arms and disconnect the wiring harness from the drive motor connector. 8. Remove the green ground wire from the motor ground terminal. 9. Remove the 1/2? hex-nut from the splutch pulley and remove the pulley. 10. Unsnap the cam splutch snap-in from the motor support and remove the snap-in. 11. Remove the four 1/2? hex-head bolts from the motor support.12. Remove the splutch spring, slider, and cam ring from the gearshaft. 13. Remove the clip from the groove in the gearshaft.14. Pull the motor support off the gearshaft.15. Remove the motor shield from the frame.16. Pull the brake band support assembly off the frame post.17. To remove the brake assembly:a) Pull the brake spring and slide the end off the tub support. b) Rotate the brake arm clockwise (CW) to fully expand (loosen) the brake band, then pull the band assembly, its spring, and the brake arm off the tub support.18. To remove the gearcase assembly: a) Remove the five hex-head bolts from the tub support.b) Pull the gearcase and tub support from the tub." Good Luck and Thanks 

Arti for Model Number lcr7244dq2

Answer Hello Arti. If leaking above the gear case, you will need to replace the seal 3968381, and the hub assembly 285709. Hope this helps. 

Mike

Answer Can you provide the model number?