Glass, Outer (white Model)

Avis K for Model Number mh7155xmb0

Answer Avis, There's really no need for "gluing" the glass panel to the outer door frame, if the door is reconstructed properly. But, if you wish, you could use a little Black high temp RTV sealer/adhesive (available at most auto parts suppliers or home improvement centers, but be very careful with the adhesive, don't get it on the door glass or outer door panel. Thanks 

Kathleen for Model Number MH714oxfq -0

Answer Kathleen, No, You don't have to remove the door from the microwave, but it makes it a lot easier to work with. Just follow the remainder of the instructions we supplied to you, and you'll be fine, be careful. Good Luck and Thanks 

Jc for Model Number Whirlpool Microwave - Model MH6141xKq

Answer Hello JC. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. Hope this helps. http://forum.appliancepartspros.com/microwave-repair/255-microwave-handle.html 

Kathleen for Model Number MH714OXFQ-0

Answer Kathleen, Do you need the door frame 8169481 the door glass 4393725 or possibly both. It's a pretty easy repair, I'm sure you could handle it. Heres some basic information : " IMPORTANT: When you work on the microwaveoven, be careful when handling the sheet metalparts. Sharp edges may be present, and youcan cut yourself if you are not careful. 1. Unplug microwave oven or disconnect power. 2. Remove the air grille. 3. Remove the 1 T-10 Torx® screw from the top hinge of the door. 4. Lift the door up and off the other hinge to remove the door. 5. Place the door face down on a protective surface. (All removal procedures assume the door is face down with the handle to the left.) Choke seal removal: 1. There are 4 tabs on the top edge, 3 tabs on each side and 5 tabs on the bottom edge. 2. Use a putty knife to open the gap between the door frame and the choke seal. 3. Locate each tab and use a flat blade screwdriver to gently lift the choke seal and release each tab. Place the screwdriver in the slot directly beside each tab and lift from there. 4. Only lift enough to release each tab all the way around the choke seal to avoid bending and possibly breaking the choke seal. Inner door removal: 2. Beginning at the bottom left corner, work your way across the bottom edge to release 4 tabs. Release 3 tabs on the right edge and 2 tabs on the left edge. 3. Gently lift the inner door from the bottom edge to release the 4 clips along the top edge. Handle removal: 1. Remove two screws from the door bracket that secure the handle to the front of the door. 2. The handle can be replaced without regard for orientation of top and bottom. Door bracket removal: 1. Remove two screws that secure the door bracket to the door frame. 1. After removing the Inner door, turn it over. 2. Each door latch is secured with one screw. Remove the screw and slide the latch out of the slot in the inner door. Outer glass removal: 1. Press the 5 tabs at the top edge of the outer glass that secure it to the door frame. 2. Lift the glass at the top left corner just enough to slide the glass to the left and up from under the tabs on the right and bottom edges. Air grille removal: 1. Unplug microwave oven or disconnect power. 2. Remove the two screws from the top of the grille. 3. Pull the top of the air grille forward, lift the bottom tabs from the slots, and remove the grille." Good Luck and Thanks 

Randy D. for Model Number GH7145XFQ-O, serial # XCJ2628020

Answer Hello Randy! The white outer door is part number 8169471 and the handle is part number 4393777. Thanks!