Handle, Door (black)

Suzy for Model Number KEHC309JBL3 Oven Door Handle AP3866388

Answer Suzy, First, remove power to the wall oven, and remove the door from the oven "To remove the oven door: 1. Install a pin in the hole of each oven door hinge hanger.2. Close the oven door as far as the two pins will allow. 3. Grasp the sides of the door and lift the door until it stops, then pull the hinge hangers out of the slots. To reinstall the oven door: 1. Grasp the sides of the door and tilt it back at a slight angle, then insert the hinge hangers into the hinge slots as far as they will go. 2. Rotate the top of the door towards the oven so the hinge hangers fit onto the support pins. 3. Close the oven door as far as the pins will allow, and make sure that the hinge hangers are fully seated on the support pins. If they are not seated properly, the door will not close tightly and may be off-center. To seat the hinge hangers, open the door slightly, and push in on the bottom until the hangers are fully seated.4. Open the oven door to its fully open position and remove the two hinge hanger pins. 5. Close the oven door completely and check it for proper operation and alignment.REMOVING THE OVEN DOOR GLASS, HINGES, & HANDLE 1. Remove the oven door from the oven . Place the oven door on a padded work surface with the front decorative glass facing down. 3. Remove the two top door liner screws and the two door glass bracket screws, and lift the liner assembly off the decorative door glass and handle. 4. To remove the outer door glass: a) Remove the three outer glass holder screws and two outer glass bracket screws from the door liner. b) Lift the outer glass with the glass holder off the door liner. c) Remove the bracket. At this point, you should be able to tighten the door handle screws, You may want to use some "Loc Tite" on the threads of the handle screws, and/or washers on the handle bracket screws, to keep them from loosening in the future. Good Luck and Thanks