The handle is loose & does move up & down. I need to access the screws to tighten the handle without destroying the handle. HOW DO I ACCESS THE SCREWS??
Answer Hello Richard. 1. At the right end, flex the handle base away from
the surface of the freezer drawer. Simultaneously
slide the door handle removal card (can us an old credit card to release the handle) that came with
your refrigerator under the right side base of the
handle. Slide the card to the line indication or until
it stops, which will be approximately 11/2".
2. With both hands, firmly grasp the handle towards
the right base.
3. Slide toward the left, lift and remove from the
surface. To reinstall the handle 67004373: 1. Align door handle clips slightly to the left of the
tabs attached to the freezer door.
2. Rotate the handle so the left base is flat against
the door. 3. Push the left handle
base against the left
door tab and slightly
to the right, just
enough to allow it to
4. While firmly supporting the left handle base against
the door, align the right base of the handle with the
right tabs that are attached to the door.
5. Now, while firmly holding the handle at the left and
right bases, gently slide the handle towards the
right until the right base settles in. The handle
should now be flat against the face of the freezer
door at both the left and right bases.
6. With hands still firmly keeping the handle flat
against the freezer door, you may have to reverse
directions momentarily to assure clip/tab
engagement. Then firmly slide the handle to the
right until it clicks. The audible "click" indicates
that the fastening clips are securely interlocked. Hope this helps.