How do I install this? Thank You
Answer Hi Liz. You remove power. Then you get a Torx- 20 size screwdriver to remove the inner panel. Then you will simply pull the latch system off the back side of the console.At this point it simply "sits" in place between The 2- left and right bosses that accept the round side post on the side of the latch body. Unfortunately 90% of the time the back of the console is broken, part # W10254847 . This is caused by the installation may have been incorrect. Remove the lower kick p-late and use a flashlight to see if the back legs are all on the floor snugly. If you have the installation guide it will show how to use a torpedo level and remove the rack. Then place the level on the side support rail to see if the unit is level front to back. Then put the level on the inside of the door panel at the lowest side for the horizontal side to side level. This will allow proper alignment of the door ( a separate part) to the cabinet area. While the unit is full of hot water and dishes, it will "relax" the tub. If the legs are not positioned correctly, this will allow the door and latch area to misaligned and break both the console and the latch itself. So by correcting the level , this will allow the parts to last longer. Thank You.