Harns-Wire

Laurie for Model Number ATF1910DR

Answer Hello Laurie. If the water that was poured in did not dump, you will need to replace the icemaker, not the water valve on the unit. 

K.c. for Model Number amana scd25tw

Answer Hello K.C., Remove the white plastic cover from the front of the icemaker assembly. It just snaps on. Once this is off, turn the icemaker and look at the side where the harness connects. On the side of the icemaker there is a small square hole where you can see the plastic molex connector that plugs into the icemaker. Using a small screwdriver, press in on the side closest to the wires. As you do this, pull on the harness and it should slide right out. It will insert without the use of any tools. 

Rand for Model Number ASD2620HRB

Answer Rand, the icemaker harness used on your model ASD2620HRB should be part number W10146387. Thanks. 

Randall for Model Number ASD2620HRB

Answer Hi Randall. The ice maker wire-harness for your unit is part # W10146387. Please call A.P.P. Customer Service @ 1-877-477-7278. Thank You. 

Don for Model Number MBF1956KEB

Answer Don, The first thing to do is unplug the power cord and tape the freezer drawer light switch closed. disconnect the wires at the fill valve and attach the meter leads to the wires. Using the jumper wire, insert the ends into the "T" and "H" openings in the control head and check for 120 VAC at the wires, when the rake arm reaches the 1 to 2 O'clock position, Good Luck and Thanks 

Leland S. for Model Number AP4135008

Answer Hello Leland. If you replaced the wiring harness D7813010 and the unit still does not work, you have another problem other than the wiring harness. Hope this helps.