Hinge, Door

Jim for Model Number RF385PXEN 0

Answer Hi Jim. Carefully use a pair of vise- grip pliers to cock each door hinge open and then make sure there is a steel nail inserts in the hinge aligning holes to keep it locked open. Then the door hinges need to be equally lifted and (gently) held up in place with your knee. Then put the hinge all the way on the top of the receiver hinge cross pins. It may at this point take a careful knee support and a gentle rock in place. This will allow the door hinge to be placed down onto the inner cross pins. Once in place, open the door fully. Remove the steel nails. Then cycle the door open and closed a couple of times to insure correct operation. Thank You. 

Michelle

Answer Hello Michelle. We will need your model number to help you with this. Please post your model number with a new question on the parts page. Thank you. http://www.appliancepartspros.com/modelnumber_locator.aspx 

Robert for Model Number 790.75993101

Answer Hello Robert. Yes, based on the information you provided, it sounds like the door hinges 316216500 and 316216501 is bad and will need to be replaced. Hope this helps. 

Don M. for Model Number ap2990242

Answer Hello Don. Make sure the locking tab is pushed down and holding the hinges 8053807 open. Then insert the hinges in the slots and lift upward as you are sliding the hinge forward and you will feel it drop into place. Hope this helps. 

John

Answer Hello John. Yes, based on the information you provided, you will need to replace the door hinges 8053807. Hope this helps. 

Frustrated for Model Number rf364pxkq1

Answer Hello. Make sure the door hinge 8053807 is seated properly inside the oven door. Also install the screws to hold the hinge in place then reassemble the oven door. Hope this helps.