How do I get the front off this dryer to check out the thermostats?
Guest
Answer Hello! You will need a small thin blade screw driver or a stiff putty knife. Approx two inches in from each corner at the top there will be alignment tabs. You can insert the screw driver in the seam, pry out and lift up. This will release the front panel. But first you have to remove the two screws holding the lint filter housing to the top. Remove the two 1/4" screws on the inside approx 3" down from the top, disconnect the door switch wires, pull out at the top of the panel and lift it off the clips. Hope this helps!