I need step by step instructions on how to replace this hose.
To change out the hose you will need to unplug the washer. Turn off the water supply to the washer. Disconnect the hot and cold water hoses from the rear of the washer and remove the end of the drain hose from the standpipe. Take the washer lid closed. Carefully lay the washer on its front panel, place padding on the floor to protect the surface. Loosen the clamp and pull the drain hose off the pump. Not that there is a tab on the outlet connector that fits into a slot in the hose. You can now remove the drain hose and install the new hose.
I need the hose that attaches to the bleach tray. Can you tell me what part it is?
Answer Jim, the bleach dispenser hose comes with the dispenser itself. Your part number is W10161863. Thanks!
why does water puddle on the floor during the spin cycle
Answer Joe, First check the water inlet hoses and faucets for drips, Then fill the washer with a hot wash setting and detergent only,drain the washer and see if you have a slow drain that is backing up and over the top of the drain standpipe. It may not be the washer leaking at all. Good Luck and Thanks