Ht Trans S

Armando F. for Model Number Maytag HAV2460AWW

Answer Hello Armando. If the tub bearing is bad and roaring, then the transmission kit will fix that problem. You will need to change the snubber 21002026 for the tub balance issue. Hope this helps. 

1 person found this answer helpful.

Rapsurfer for Model Number mavt236aww

Answer Hello Rapsurfer. Check the thrust bearing 12002213 and see if it worn or broke. Make sure it is releasing the brake properly. Hope this helps. 

1 person found this answer helpful.

Andy for Model Number MAVT754EWW

Answer Hello Andy. If the agitator does not turn while manually turning the belt, you have a bad transmission. Hope this helps. 

1 person found this answer helpful.

Brandon for Model Number MAV9600EWW

Answer Brandon, The loud screech at the end of the spin cycle would be an issue with the brake 35-6714 and stator 35-6918. You would want to replace these. The not going into the spin could be a problem with the thrust bearing 12002213. 

Sam for Model Number MAV9501EWQ

Answer Sam, The transmission isn't the issue at this point. Were it, you'd also have a poor or no spin situation. If the thrust bearing 12002213 assembly has worn or become distorted, the cams won't engage properly, and won't properly lift and disengage the brake rotor properly causing a drag and noise. 

Dennis for Model Number mav8551aww

Answer Dennis, You will want to check the pump to make sure that the pump and hoses do not have clogs in them which would cause the unit to not extract the water fast enough and not allow the unit to spin properly.