any diagrams on how to replace ice chute door
Answer Warr, Once you have the bracket out and can access the door lever, it's just a "snap" out the old and "snap" in the new door flap, here are the instructions, " 1. Disconnect the unit from the power source. 2. To remove the grill from the fountain sump, pull straight out. 3. Remove the two escutcheon mounting screws. 4. Carefully raise the escutcheon up and off the fountain assembly. 5. Disconnect the quick disconnect edge connector from the PC fountain switch board. 6. Remove the three fountain bracket mounting screws. 7. Carefully pull the assembly out of the fountain housing. You now have full access to solenoid, dispenser mechanism, PC fountain control board and light socket. 8. To repair the assembly, disconnect electrical quick disconnect."
I'm looking for an ice chute door flap seal kit for a model MSD2735GRB. Is there a part number for the whole kit or will I have to buy each part separately (i.e. flapper, solenoid, strike arm, solenoid plunger and instructions). Your help is greatly appreciated.
Answer Hello Brandon,
The part I believe you are looking for is a kit designed to replace the "ears" that the hinges pivot in. These were such an issue that the manufacturer designed this kit: Ice Door Kit 8201756 (with metal bracket), to correct the issue. The only other fix for the issue was to replace the entire door which cost in excess of $500.00. I don't think the solenoid comes with the kit but the rest including instructions are included. Let us know if we can assist you further in your repair.