Icemaker

Kevin for Model Number 10655546402

Answer Hello Kevin. Yes, it comes with the module attached. Hope this helps. 

1 person found this answer helpful.

Kevin for Model Number 10655546402

Answer Hello Kevin. These are not to hard to install. Just remove the screws holding the icemaker in place, and disconnect the wires to the icemaker. You will need to remove the arm from the old icemaker and install it on the new one. Reinstall in reverse order. Hope this helps. 

1 person found this answer helpful.

Wayne for Model Number Kenmore 106 54512300

Answer Wayne, The old harness will work for the new icemaker. To remove the old icemaker you would push in on the clip on the harness and remove. The new harness will just slide into the new icemaker and clip into place. 

Jeff for Model Number 106.59422801

Answer Hello Jeff. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. http://forum.appliancepartspros.com/refrigerator-freezer-repair/181857-amana-icemaker.html 

Troy for Model Number ED5JHEXTD00

Answer Troy, You will want to pull the front cover off icemaker and check the large gear to see if the pins in the middle are broken. If they are broken you will need to replace the icemaker module W10190935. If not then you would want to pull the icemaker out and check the fill tube for being frozen. If the fill tube is frozen then clear the ice and replace water valve W10408179 due to seeping. You can cycle the icemaker by putting a jumper wire between T and H on the icemaker module. 

Matt for Model Number GD5SHAXLQ01

Answer Hello Matt, The part number for the complete icemaker assembly is 2198597. You may also want to check to make sure that your emitter board is good. When you open freezer door, on the right side there is the icemaker shut off. On this panel there should be a light flashing. When you close the flapper on the left wall without blocking the opening then you should have a solid red light on the right panel. If it continues to flash then the emitter 4389102 is bad and would need to be replaced. When you initially open the door and if there is no light then push the flapper and the light switch and see if the light is flashing. If not then you have a bad board as well and would need to be replaced.