I just bought a new control board from you , but when I try to set a temperature it takes a long time to reach it the temperature. when you place something in it to cook it does not cook at time set , what could be the problem.
Answer Hello Tom,
You will want to check to make sure that the oven sensor is good. The sensor should have an ohm reading of 1090 ohms at room temp. If it does not then you will want to replace. Also check to make sure that the ignitor is pulling 3.2 to 3.6 amps when lighting oven.
How is the sealed burner removed to replace the ignitor? The oven ignighter was a 10 minute job since there were no sealed parts to contend with.
Answer Hello Herman,
The sealed burner will come out easily by turning the complete burner assembly 1/4 turn counterclockwise. If it will not turn easily, I have an oil filter wrench that has a rubber strap that works great for freeing up a seized burner.