Impeller

Larry for Model Number kudp01ilbs3

Answer Hello Larry. You must remove the motor to replace this part. The impeller unscrews off the motor shaft of the unit. You need to hold the motor from turning when unscrewing the impeller. Usually it is easier to replace the motor assembly... more instead of just the impeller 

STORM77 for Model Number kudp01ilbs1

Answer Hello Storm77. The impeller 8193951 unscrews off the motor shaft of the unit. You need to hold the motor from turning when unscrewing the impeller. Usually it is easier to replace the motor assembly instead of just the impeller. 

Dave for Model Number kuds03ftwh3

Answer Hello Dave, To remove the motor from the sump housing you will want to remove the securing bolt securing the wash motor and drip shield in place on the pump assembly. Once removed turn motor approximately 1/4 turn until it stops. Pull motor straight back from the sump. This may take some effort to dislodge. The volute will remain attached. Keep in mind when reinstalling the wash motor and the volute, do not pinch the volute seal between teh volute and sump. Use a small amount of rinse aid on the volute seal to help installation. Once pump is off you can remove the impeller and volute. To remove the impeller, slide a flat blade screwdriver into the back of the wash motor to keep armature of motor from turning while unscrewing the impeller clockwise. Take care not to scratch or nick the motor winding. Unscrew the impeller then line the arrow of the volute up with the triangle mark on the pump and lift off volute. Reinstall in reverse. 

Anthony Acierno for Model Number KUDS01DJSS0

Answer Hello Anthony, If you replace the impeller, you should order new "O" rings to eliminate the possibility of a water leak.I personally would not fool around with it. I would replace the pump and motor assembly W10239405. The only disadvantage to this is the expense. The headache of getting it all back together and finding that you have created a leak, is not worth it at all. 

JSMITH8918 for Model Number GU2500XTPQ7

Answer Hello Jsmith8918. Based on the information you provided, it sounds like the impeller 8193951 is bad and will need to be replaced. Hope this helps. 

Cg for Model Number kudi02crbs1

Answer Hello Cg. Check and see if the water is filling up close to the bottom of the heater assembly. If not, replace the water valve. Also, check and make sure the filters inside the unit are clean and clear from debris. Hope this helps.