Impeller seal is leaking. I've removed the pump and motor. How do I remove the impeller from the motor shaft?
Answer Hello George. These parts will pull off the D shaft. You will need to remove the front disk to do this repair. Hope this helps.
1 person found this answer helpful.
My dish washer will not pump water out
Answer Hello Glenn,
This is most commonly caused by a clog in the drain system of the unit. If all screens are clear the issue is most likely the pump and motor assembly W10247394.
Dishwasher fills up and washes but doesn't drain will the impeller replacement fix this problem? If so I need the correct part number. thank you
You will need to get into the collector and make sure that it is clear and that there is nothing that is clogging the pump assembly and make sure that the check ball is moving freely. If these check ok then also check drain line to make sure that it is not plugged up. If all this checks ok then the pump impeller would be the most likely issue. Part number 4386996.