How to install the drawer kit?
Answer Hello Pat. 1. Open drawer to fully open position.
2. Remove upper basket.
3. Remove screws one in each rail marked on side of
4. Lift front of drawer up and out to remove drawer. 1. Remove screws inside plastic rail retainer.
2. Remove rails from retainer by depressing plastic tabs
on back side of retainer.
3. Slide rails off of retainer. 1. Remove drawer assembly (see Drawer Assembly
2. Extend drawer rails to full open position,remove rails
from retainer by depressing plastic tabs on back side
3. Slide rails, rack and pinion gear 12002497 off of retainer.
4. Reverse procedure to reassemble.
Note: When reinstalling rails, rack and pinion gear after
latching rails in place, slide rails, rack and pinion
to the fully closed position and then pull out to
synchronize the rack and pinion gears. Hope this helps.