Refer yesterdays telephone /email replacimg RH end panel in subject refigerator
Removal of tempature slide adjuster is very dificult as the opening for the clip is about 1/4 inch wide and the clip is about 1/2
refer yesterdays Email from Kyle
When removing the right side end cap for the deli drawer, once the end cap is off, the rear piece that goes horizontal from the endcap will unclip. Remove this piece. Once this has been removed the linkage has push tabs on the back the hold it in place. Starting from the back end you will release the link arm by pushing the tab. Once all the tabs have been pushed and the link arm can rotate then you would twist it to where the elongated part that the slide goes through is turned for the slide tab to release. Then the slide will just pop off and you would install in reverse.
Thanks. But how to reach that clip??? It is inside behind the end cap.
Answer Mike, Correct, you have to remove the end cap from the fridge wall, the end cap has three screws holding it to the wall, Once you disconnect the shifter lever from the air control slide, you can unsnap the lever from the end cap and lift / slide it out of the opening and install it into the new end cap. Thanks Again
I have to replace broken Endcap AP4456441 but Knob AP4078991 is on the way. How to take out Knob AP4078991 and not brake it? Thanks
Answer Hello Mike. The temp knob 67003791 has a locking tab holding it in place. You will need to release this clip and then you can remove the knob in the unit.