Lever, Ice Dispenser (black)

ABCUTIE115@AOL.COM for Model Number ED5FHEXSB02

Answer Hello Abcutie, To remove the front cover of the dispenser assembly, pull out drip tray. At the bottom of the dispenser front there are 2 grooves. Insert a flat blade screwdriver into the left side and pull out on cover. This will pop the left side loose. Then slide the screwdriver under the other side and pop it loose. Lift up on the cover and it will come off. You may want to check the hooks that hold the dispenser door pin in place to make sure that they are not broken. If broken you will need to install kit number 8201756 to repair. 

RICK777 for Model Number EC3JHAXRL13

Answer Rick, We will be sending you some basic dispenser access information. Basically you will need to remove the dispenser facade, switch bracket assembly in order to replace and properly mount the actuator paddle. Thanks 

Richard for Model Number ED5GHEXNL00

Answer Hello Richard. The manufacture does not offer instructions on removing this part. It looks like there is two screws holding it in place. Once the screws are removed, it should pull out of the dispenser assembly. Hope this helps. 

Richard for Model Number ED5GHEXNL00

Answer Hello Richard. You can not remove the main housing. It is made into the door. Hope this helps. 

Richard for Model Number ED5GHEXNL00

Answer Hello Richard. The tabs on the side of the lever snaps into place. You will need to unsnap these tabs to remove the ice lever. Hope this helps. 

Tanya

Answer Hello Tanya. Yes, it can be replaced by disassembling the dispenser. They are a little tricky to do, but you will not have to replace the whole dispenser assembly. Hope this helps.