How does this lever, overflow switch install ?
Manny for Model Number DU1055XTVT2
Answer Hello Manny. You will need to remove the toe panel off the dishwasher and remove the cover on the float switch. Once the cover is removed, you can access the lever 8268892 and install it into the housing. The float will rest on the lever and as the water fills, it rises off the lever. Hope this helps.
Dishwasher seems to go thru cycles but does not clean dishes or silver, it seems like there is no water being squirted out of the lower spray arm although there is water getting into the washer, also detergent is not being released from dispencer.
Mike for Model Number DU1100XTPQA
Answer Hello Mike. You will need to check and make sure the water level is high enough for the dishwasher to operate properly. It should fill up to the bottom of the heater inside the dishwasher. If it is low, you will need to replace the water valve W10158389. As for the dispenser not dispensing soap, if the door is not opening, you will need to replace the dispenser W10224428. Hope this helps.