My water level has lost the tension and will not dispense any water. What parts are needed to fix this problem?
You will want to check the dispenser lever and make sure that it is not broken. If the lever is not broken then check the bracket that the switch sits on and make sure that the switch is not loose. The pins on the bracket could have broken causing the lever to not make contact with the switch to dispense water.
Sometimes the water dispense drips after pouring a glass of water. I have to tap the water lever a couple times to stop the drip.
Answer Hello Rodney,
This can be caused by three things. There can be air still in the water filter if it has been recently replaced. It can be caused by air in the water supply. It can also be caused by a pinhole in a water line. This would be evident from a very small water leak that is sometimes un-noticeable since it would be a small enough water leak to only put out less than a thimble full of water per dispense.