Limit Switch

Paulibra for Model Number MSD2456GE

Answer Hello Paulibra. For the issue you are having, you will need to order and replace the actuator pad 61003804 on the unit. You will need to apply grease on the button inside the pad to help in preventing the issue you are having. If you try the grease on the old pad, and the issue continues, you will need to replace the pad in the unit. 

Jim for Model Number MSD2356AEW

Answer Hi. Remove the Fountain spill catcher. Remove the hidden lower screws and lift up and out to remove the fountain control panel. The control board unplugs from 2 wire connections. Make sure they are connected tight and are not pinched. If you have to fold the ribbon cable, fold it at a 90°. We have seen where both fountain boards are affected as both boards need changed as well. Replace the main board part # 61003425 and momentarily connect and test the fountain board part # 61003421 along with it. If it does not stop the continuous light and return normal commands then change both boards. It may be possible that you have taken a power surge at one time and wiped out both boards. Thank You. 

Phil I for Model Number MSD2454GRW Maytag

Answer Phil, Here is the help you need : "Ice and Water Fountain Bracket Assembly Removal 1. Disconnect the unit from the power source. 2. Pull straight out to remove the grill from the fountain sump. 3. Remove the two escutcheon mounting screws. 4. Raise the escutcheon up and off the fountain assembly. 5. Disconnect the quick disconnect edge connector from the PC fountain switch board. 6. Remove the three fountain bracket mounting screws. Checking and Replacing the Actuator Switch: 1. Disconnect the unit from the power source. 2. Perform steps 1 through 6 of To Remove Ice and Water Fountain Bracket Assembly. 3. Check the continuity of the switch if defective go to step 4. 4. Remove the mounting screw. 5. Remove the switch. 6. Remove the wire leads. 7. Install new switch in reverse order of removal. Thanks and Good Luck 

Jose for Model Number MZD3766GES

Answer Hi Jose. There is a single wire , beside the larger pin connector that you had to unplug going into the kit. It is on the lower left side. This wire goes to the light neutral and the board neutral. Inspect the entire connections to the controls carefully and inspect all connections. Hope this helps. Thank you.