Microcomputer

Todd for Model Number RS696PXGQ4

Answer Todd, Sounds like the control board has reset to the "Celsius" temperature mode, after the power failure : The default is Fahrenheit (° F). 1. Press the BROIL pad for 5 seconds. The temperature will be displayed in degrees Celsius indicated by the "C"” in the temperature display. 2. To return the display to degrees Fahrenheit press the BROIL pad again for 5 seconds. “F” will show in the temperature display. 

Brian for Model Number Whirlpool RS696PXGQ8

Answer Brian, To replace the control board you would pull the unit out and disconnect the power to the unit. Remove the rear cover of the control panel and take the screws holding the control board on out. Install new board and reassemble. 

Carolyn Ross for Model Number rs696pxgq6

Answer Carolyn, You will need to check the insertion end of the keypad ribbon and make sure the end was not accidentally coverred with lubricant or plastic material on the production line. Check and make sure the ribbon is not creased or torn anywhere. Make sure the end of the ribbon is inserted into the microcomputer connector properly and tightly. " F2 E1 Keypad keytail not connected 1. Check keypad connector for firm connection.2. Press CANCEL. If error code returns after 60 sec., replace keypad.3. Replace control." After these checks, if the problem persists, re order a new control panel/keypad assembly. Thanks 

Dc for Model Number RS675PXGQ5

Answer Hello DC. Based on the information you provided, it sounds like the microcomputer 8186024 is bad and will need to be replaced on the unit. 

Sherry K. for Model Number RBS275PDS12

Answer Hello Sherry, Here's a short list that should cover everything: 1. If door is latched: Disconnect power from unit. Check wires and connectors from control to door switch, then from door switch to control. If no damage to wires and all connectors okay, proceed to step C. Replace door switch. Re-apply power. Press and hold any key down for 1 minute to clear F5 failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct. 2. If door not latched: Disconnect power from unit. Check wires and connectors from control to latch switch, then from latch switch to control. If no damage to wires and all connectors okay, proceed to step C. Repeat steps A and B for door switch. 3. Measure door switch (door open = switch open small low voltage terminals). Replace switch if defective. 4. Measure latch switch (unlatch = switch open, CAUTION - oven light contacts are closed). Replace switch if defective. 5. If corrections are made in any step, reconnect power to control. Press and hold any key for 1 minute to clear R failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct. 6. If failure remains, disconnect power and replace control. Note: Applies to all F5-E... codes. Read more: http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Whirlpool'>http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Whirlpool Range / Stove / Oven Fault Codes#ixzz1vAO2t5F1 http://www.appliancepartspros.com Let us know if we can assist further. 

Mike D. for Model Number RBS245PDQ-8

Answer Hello Mike. Yes, as long as the size was entered, and the unit is working properly, then the microcomputer 8186024 is programed correctly. Hope this helps.