Hello - Two of my five burners won't ignite when I try to start with their respective control knobs. However, these burners will spark when I start the other other burners with the control knob. Is this an issue with the spark module?
Answer Hello Rob,
You will want to check continuity of the ignition switches. Turn off gas to unit. With valve turned in on position check across the leads of each switch for continuity. If there is no continuity then the switches are bad. Also check to make sure that the ignitors are not bent to where they will not allow sparking. If these check ok then also check the wiring from the switches to the spark module to make sure that there are no broken or damaged wires.
Hello I was wondering I have a Jenn air and I think it's a jdr8895aas. I just replaced the oriface and its a 12k but I need the valve because it is stuck and I can't turn it on. Probably due to corrosion from the salty air . What size valve do I use the 16 or 9? Also my ingniter doesn't click or work how do I determine what part is bad.
Answer Hello Stefan! You will need the 9k burner control valve 12002269, this is also used as the 12k burner valve. Make sure that the area around the igniter is not dirty from food/debris. If it is clean, try replacing the ignitor- part number 8523793. If the spark module ignites the other burners and this one just doesn't click, you can try putting a good igniter in it's place to verify it's just the igniter. If it doesn't work he could have a bad switch or module. Hope this helps. Thanks.
My middle ignitor does not "click". It will not "click or spark when any of the other burners are turned on. Also neither oven goes into "clean" mode when their buttons are pushed. I need help Charlie
Answer Brad, as for the middle burner not sparking, You will need to remove the burner cap and check the burner base and cap for debris and spillage and the condition of the spark igniter 8523793 . If thats the only burner with an issue, if alls Ok you will need to remove all the caps and burner bases and raise the cooktop to check for a damaged wire to the igniter 7527P023-60 from the spark module 74009098 on the back of the range. As for neither oven not going into the "clean" cycle, there should be an error code in the display when the cycle is programmed . what is the error code ? and you cannot program both ovens for clean at the same time. We'll send you some tech data information that should get you through diagnosing the issues and getting you back up and running.