Motor/pump Housing Assembly

Mark for Model Number MDB7100AWW

Answer Hello Mark. Yes, the assembly 6-917113 would take care of the noise issue in the unit. Make sure there is nothing stuck inside the chopper assembly on the unit as well. 

Larry for Model Number MDBD880AWW

Answer Hello Larry. You will test across the blue and grey and blue and yellow. If there is no ohm reading, replace the motor 6-917113. Hope this helps. 

Joe S. for Model Number mdb7100aww

Answer Hello Joe. Based on the information you provided, it sounds like the PCB assembly 99002824 is bad and will need to be replaced. If the motor is new and the wires are good, you will need to replace the board in the unit. Hope this helps. 

Joe S for Model Number mdb71001ww

Answer Joe, The low current draw indication, could be due to several issues, If you have a multimeter, check for a momentary voltage drop at the junction box or outlet, when the motor starts, once the motor is in the run, you need to maintain 108 to110 VAC. Check your sprat arms for obstructions and debris. and that the washer is filling properly( water level after a fill and 3-5 min. wash, should be 1/2 way up the heater element, to coverring the element. Make sure the detergent and the rinse aid are not "foaming" during the cycle. Thanks and Good Luck 

Joe S. for Model Number mdb 7100 aww

Answer Hi Joe. Behind the lower kick plate the is a supplied wiring diagram. If not there look in between the inner door panel under the controls areas. Then use a volt/ohm meter part # TJMA-DM1 in the junction box to see if you have 120 vac and tight connections. When the new motor assy was installed, was the chopper blade binding ? Check this. Make sure the door switches close well and the motor is getting the 120 vac . Thank You.