My washer will not spin. The door locked light comes on. I looked at the control board and found no evidence of fried resistors. Could it just be a bad wax motor?
Answer Hello Brad. If the light comes on, the motor is good. You will need to check the balance switches and the spin enable switch. If all are good, then the motor kit will need to be replaced on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
The soap dispenser door does not open at any time automatically. The spring is okay. I thought it might be the wax motor. Please help. Thanks
You are on the right track with the wax motor being the issue. You can test the wax motor when the unit is calling for the detergent cup to open. Check to make sure that there is 120 vac getting to the wax motor. If there is then the wax motor is faulty and would need to be replaced and if not then the issue would be the controls/timer.
Washer won't spin and I'm getting Error Code E43. Therefore, will this Wax Motor fit on my Washer (or do I have to order the entire Door Lock Assembly 131763202).
Answer Robin, Sorry but No, the 22002119 wax motor will not work on your washer latch assembly. You will need to repalce the complete door latch assembly 131763202 in order for your washer to operate properly. The E43 code indicates and issue in the control board. and it usually does is due to a faulty door latch assembly.