Where's the regulator on the whirlpool super capacity 465? I think the regulator is the one that connect to the gas line, but I can't see the thing to open and I can't see the nat or the lp.
Edison C
Answer Edison,
The regulator is what connects to the gas line. There should be a round piece in the middle with a slot for a screwdriver. Twist this off and the inside there would be a cap that you would flip. Then put the screw back in.
Where are the orifice located on a whirlpool super capacity 465?
Edison C
Answer Edison,
The orifice should be located on the burner base under the cap.
I think I forgot to add my email to a previous question so I'm resending my question.
What Nat. gas spud kit is listed for Whirlpool Super Capacity 465 30' freestanding top surface burner orifices? Would there but any compensation to size when range is in high altitude area? (10,000 ft.) I'm switching it from LP spuds and do not have the original factory shipped Nat. Gas spuds. Thank you in advance for the information.
Regards,
Stephen
Stephen for Model Number SF365PEGQ5
Answer Stephen, the manufacturer does not offer a NG spud kit for your unit. The left rear orifice if part number 8273066, the left front orifice is part number 8273064, the right front orifice is part number 8273065 and the right rear orifice is part number 8273067. Please see the following link, reference page 7-8, for converting you regulator. If the unit does not work properly due to high altitude, you will need to contact your local gas company. Thanks! https://www.whirlpool.com/digitalassets/MLPDF/Installation%20Instructions%20-%208273170.pdf