Orifice Tube Assembly

Randy for Model Number magic chef 3167xtw

Answer Hello Randy. This unit does not require any separate parts to convert the burners to LP. You will turn the orifices 2 1/2 turns down and refer to your use and care guide for proper regulator conversion. Thanks! 

Donna O. for Model Number 318a341w

Answer Hello Donna! The unit does not require a conversion kit, it is self adjustable. Adjust the orifices two full rounds ccw and adjust the burner flame until its blue. Flip the cap on the regulator to LP to convert the regulator. Thanks! 

Richard P for Model Number 3448XRA

Answer Hello Richard. This model is adjustable. Tighten the orifices all the way down, then come back up 1½ rounds. Then flip the regulator from LP to natural gas. Check the flames and adjust if needed. 

Eric for Model Number Crosley Gas Stove

Answer Hello Eric! To help verify the parts or process for your appliance we will need the appliance model number. Please provide the model number for further assistance. Thanks! 

Michael for Model Number 3468xva

Answer Michael, You do not need any parts, Your range is convertable on the range. You will need to unplug the power cord or turn power off to the range, also shut off the gas supply at the wall. In your case, it's a matter of turning "ALL" the burner orifices "out" / counterclockwise 1 1/2 to 2 complete turns Adjust the air shutter on all the burners to a 3/4 open position and fine tune from there. You'll need to "flip" the regulator cap back to the NAT Gas setting. All the work can be performed using basic hand tools: small crescent wrench for the regulator cap, 1/2 in. open end wrench for the bake and broil orifice adjustments, and a 1/2 in. deep set socket for adjusting the top burner orifices. Thanks and Good Luck 

Danny H. for Model Number H3277VRA Serial # 16C403-655211

Answer Hello Danny. Twist and remove the burners from the cooktop to raise the cooktop and replace the orifice tube assembly 12001074. Hope this helps.