How do I remove the oven door?
Answer Hello Del. There are clips on the hinges that will need to be locked, and the door will lift off. Hope this helps.
1 person found this answer helpful.
The oven door will only open about 4". I can feel the door being restrained.
When last opened a loud, slamming noise was heard as if a spring had broken.
How can I free the door for removal?
Answer Hello D.D. See if it opens enough to put a nail into the holes on the hinge on both sides. If so, do that, then close until it stops and lift the door up and pull out of the receivers. Then replace the broke hinge on the unit.
I cannot get the oven door to stay closed fully so I am assuming the hinges need to be replaced. My question is how do I get this thing apart . All the info videos online refer to unlocking the hinge to remove it but mine do not have that feature. I would like to order new ones from you but would like to know what I do when I get them. Your help is greatly appreciated.
Answer Hello Walter. To remove:
1. Open door all the way.
NOTE: Two 5/32" (4 mm) Allen wrenches or
two nails of similar diameter may be used if
factory furnished door removal pins have
been misplaced. Be careful not to damage
porcelain finish. 2. Insert small end of a door removal pin
into each door hinge. 3. Grasp under handle and gently close
door as far as it will shut. Pull door out
at bottom to remove. 4. Set door aside on protected surface. To replace:
1. Fit hinge arms into slots in frame. Push in
at lower corners to insure that hinge arms
are fully engaged. 2. Open the door all the way.
3. Remove the door removal pins from
4. Close the door. NOTE: If the door does not operate freely,
you have not installed it properly. Repeat
Steps 1 to 4.