Starting up oven sometimes works and then sometimes won't.Oven igniter works.Iseewhite sparks
Answer Buhbuh, Is there any problems with the cooktop burners igniting, if not you'll need to check the gas valve assembly W10293048 for resistance and DC voltage from the DSI spark module W10331686. On the gas valve terminals, you should have a resistance reading of 215 ohms resistance from the center terminal to each of the outside terminals. Then reattach the wires, set your meter to read DC voltage and attach the meter lead to the center terminal and make a bake selection on the control. You should have a reading of 8 to 18 DCV to the outside gas valve terminals (the higher the voltage the better). Since the issue is intermittent, you probably have a weak DSI spark module.
I am geeing a F2 code on my range.I have change the temperature rod but the code is still coming on.Can you tell me what else I can do?
Answer Hello Bill. An F2 error code means Oven temp is too high.
1. Look for welded relay contacts on bake or broil relays. If this happens, replace oven control (also called clock or ERC).
2. For SELF CLEAN models: check door lock operation.
3. Look for a high resistance connection or any other cause of high resistance in the oven temperature sensor circuit. Check sensor, sensor harness and sensor harness connection at sensor and oven control. Replace sensor if found defective.
Read more: http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#ixzz2uRZ12KAG'>http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#ixzz2uRZ12KAG
If connections are good it sounds like the board will need to be replaced. The electronic control for your model is Part# W10312660